UK · EU reference Tyre Pressure

Mitsubishi · Lancer Evo · Bar

Mitsubishi Lancer Evo bar chart (2.2-2.4 / 2.2-2.4)

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this Lancer Evo 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. Under-inflation cooks the shoulders of a Lancer Evo; over-inflation wears the centre rib and bangs every cat’s eye.

Bar, PSI and kPa

Bar-led conversions around the Mitsubishi Lancer Evo. 2.2-2.4 bar is not “32-35 divided by ten”.

BarPSIkPa
2.0730207
2.2132221
2.2833228
2.3133.5231
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.4550345
4.1460414

Mitsubishi Lancer Evo placard versus sidewall

If the Mitsubishi sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (225/45R17 and others)

If your Mitsubishi Lancer Evo no longer wears the OEM diameter, start at the row nearest 225/45R17 or 205/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/45R1735352.412.41241241Sport 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
195/65R1534342.342.34234234Very common compact
215/55R1634352.342.41234241Slightly wider 16-inch
225/50R1735352.412.41241241Touring 17-inch
205/60R1634342.342.34234234Taller 16-inch
185/65R1533332.282.28228228Small / older car
245/40R1836362.482.48248248Wide touring 18-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar38 psi / 2.62 bar

How to set the Lancer Evo

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Lancer Evo numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Lancer Evo.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Mitsubishi notes

No special Mitsubishi exception: the Lancer Evo uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Mitsubishi Lancer Evo usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Mitsubishi sticker and this page disagree, the sticker wins.

Other Mitsubishi models

Questions about this Lancer Evo

What PSI if I plus-size toward 195/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/45R17, 205/55R16 and 195/65R15 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is that in bar and kPa for the Lancer Evo?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Mitsubishi Lancer Evo?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Front versus rear on the Mitsubishi Lancer Evo?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Handbook: placard · bar vs PSI · front vs rear · cold inflation