MINI · John Cooper Works Clubman · Rear

Rear axle PSI and bar on the MINI John Cooper Works Clubman

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi rear

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Loaded John Cooper Works Clubman rears often need the sticker’s second column, not a copy of the front 32-35 psi figure. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed MINI tyre.

MINI John Cooper Works Clubman placard versus sidewall

The tyre-information placard on a MINI John Cooper Works Clubman sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (245/40R18 and others)

If your MINI John Cooper Works Clubman no longer wears the OEM diameter, start at the row nearest 245/40R18 or 205/55R16 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
245/40R18	—	36	—	2.48	—	248	Wide touring 18-inch
205/55R16	—	34	—	2.34	—	234	Typical mid-compact OEM
225/40R18	—	36	—	2.48	—	248	Low-profile 18-inch
185/65R15	—	33	—	2.28	—	228	Small / older car
205/60R16	—	34	—	2.34	—	234	Taller 16-inch
215/55R16	—	35	—	2.41	—	241	Slightly wider 16-inch
195/65R15	—	34	—	2.34	—	234	Very common compact
225/45R17	—	35	—	2.41	—	241	Sport 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	36 psi / 2.48 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this John Cooper Works Clubman.

How to set the John Cooper Works Clubman

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep John Cooper Works Clubman numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the MINI John Cooper Works Clubman band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this John Cooper Works Clubman.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

MINI notes

MINI run-flats ride harshly if you overshoot. Stay in the printed band on this John Cooper Works Clubman.

Spare and inflator kit

A matching full-size spare on the MINI John Cooper Works Clubman usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this John Cooper Works Clubman than nitrogen upsells.

Other MINI models

Cooper D Paceman Cooper D Cabrio Cooper S Clubman Cooper C Cabrio Cooper C Cooper S Countryman Cooper Cabrio Cooper Clubman

Questions about this John Cooper Works Clubman

What is that in bar and kPa for the John Cooper Works Clubman?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Front versus rear on the MINI John Cooper Works Clubman?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

How often should I check a John Cooper Works Clubman?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a MINI John Cooper Works Clubman use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a MINI John Cooper Works Clubman?

No. Sidewall PSI is a maximum. The John Cooper Works Clubman placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation