UK · EU reference Tyre Pressure

Mercedes-Benz · Sprinter · PSI

Mercedes-Benz Sprinter inflation in PSI (35-45 front, 45-65 rear)

Drivetrain
rear-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

If a Sprinter owner asks “what PSI?”, start at 40 at the steering axle and 55 at the rear, then confirm the placard. Under-inflation cooks the shoulders of a Sprinter; over-inflation wears the centre rib and bangs every cat’s eye. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as 235/60R17 are not filled like a Fiesta.

Mercedes-Benz Sprinter placard versus sidewall

If the Mercedes-Benz sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

PSI, bar and kPa

PSI-led conversions for the Mercedes-Benz Sprinter band (35-45 / 45-65).

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Estimated pressure by tyre size (225/65R16 and others)

If your Mercedes-Benz Sprinter no longer wears the OEM diameter, start at the row nearest 225/65R16 or 215/65R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/65R1641582.834283400Common transaxle van
215/65R1640572.763.93276393Compact van
235/60R1741582.834283400Plus-size van
215/75R16C45643.14.41310441C-type 215
235/65R1642592.94.07290407Loaded van
225/75R1642602.94.14290414Taller load range
195/75R16C44633.034.34303434C-type commercial
LT215/85R1646653.174.48317448LT commercial

How to set the Sprinter

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Sprinter numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Payload / towing42 psi / 2.9 bar58 psi / 4 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Sprinter.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Mercedes-Benz notes

Mercedes often lists comfort versus load. Match the table to how the Sprinter is actually occupied that day.

Spare and inflator kit

A matching full-size spare on the Mercedes-Benz Sprinter usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Mercedes-Benz sticker and this page disagree, the sticker wins.

Other Mercedes-Benz models

Questions about this Sprinter

What PSI if I plus-size toward 235/60R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/65R16, 215/65R16 and 235/60R17 as a planning band.

Front versus rear on the Mercedes-Benz Sprinter?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

How often should I check a Sprinter?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Is the sidewall number correct on a Mercedes-Benz Sprinter?

No. Sidewall PSI is a maximum. The Sprinter placard is the operating target, near 35-45/45-65 psi.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation