UK · EU reference Tyre Pressure

Mercedes-Benz · G 300 · Rear

Mercedes-Benz G 300 rear tyre pressure

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Mercedes-Benz G 300 is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 205/60R16, 225/40R18 and 215/55R16 — interpolated from the catalogue midpoint, not a second factory sticker.

Mercedes-Benz G 300 placard versus sidewall

The tyre-information placard on a Mercedes-Benz G 300 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (205/60R16 and others)

If your Mercedes-Benz G 300 no longer wears the OEM diameter, start at the row nearest 205/60R16 or 225/40R18 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/60R16342.34234Taller 16-inch
225/40R18362.48248Low-profile 18-inch
215/55R16352.41241Slightly wider 16-inch
225/45R17352.41241Sport 17-inch
225/50R17352.41241Touring 17-inch
245/40R18362.48248Wide touring 18-inch
205/55R16342.34234Typical mid-compact OEM
215/50R17352.41241Plus-size 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this G 300.

How to set the G 300

  1. Park the Mercedes-Benz G 300 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a rear-wheel drive G 300 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Mercedes-Benz G 300 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this G 300.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Mercedes-Benz notes

Mercedes often lists comfort versus load. Match the table to how the G 300 is actually occupied that day.

Spare and inflator kit

A matching full-size spare on the Mercedes-Benz G 300 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Mercedes-Benz sticker and this page disagree, the sticker wins.

Other Mercedes-Benz models

Questions about this G 300

Front versus rear on the Mercedes-Benz G 300?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Is the sidewall number correct on a Mercedes-Benz G 300?

No. Sidewall PSI is a maximum. The G 300 placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Mercedes-Benz G 300 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What is that in bar and kPa for the G 300?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation