UK · EU reference Tyre Pressure

Mercedes-Benz · B Electric Drive · Front

Mercedes-Benz B Electric Drive front tyre pressure

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi front

34

2.31 bar · 231 kPa at the steering axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A 3 psi miss on one front corner of this B Electric Drive shows up as a wander before the TPMS lamp bothers you. Target 34 psi (2.31 bar) cold. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Mercedes-Benz tyre. Battery mass on this {make} {model} makes a 4 psi-low tyre cost range as well as heat.

Mercedes-Benz B Electric Drive placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this B Electric Drive is the pillar sticker, near 34/34 psi.

Estimated pressure by tyre size (215/50R17 and others)

215/50R17 is the first planning size here. 225/50R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R17352.41241Plus-size 17-inch
215/55R16342.34234Slightly wider 16-inch
225/50R17352.41241Touring 17-inch
205/55R16342.34234Typical mid-compact OEM
195/65R15342.34234Very common compact
255/40R19372.55255EV 19-inch aero wheel
205/60R16342.34234Taller 16-inch
245/40R18362.48248Wide touring 18-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

Steering feel on the B Electric Drive lives on this axle. Do not drop front pressure to “soften” a plus-size 225/50R17; you will roll the sidewall in a roundabout.

How to set the B Electric Drive

  1. Park the Mercedes-Benz B Electric Drive for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a rear-wheel drive B Electric Drive is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Mercedes-Benz B Electric Drive band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this B Electric Drive.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Mercedes-Benz notes

Mercedes often lists comfort versus load. Match the table to how the B Electric Drive is actually occupied that day.

Spare and inflator kit

A matching full-size spare on the Mercedes-Benz B Electric Drive usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Mercedes-Benz B Electric Drive on the printed band; use 215/50R17 and 225/50R17 only as a map for non-OEM wheels.

Other Mercedes-Benz models

Questions about this B Electric Drive

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Mercedes-Benz B Electric Drive?

No. Sidewall PSI is a maximum. The B Electric Drive placard is the operating target, near 32-35/32-35 psi.

How often should I check a B Electric Drive?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

When does TPMS warn on a Mercedes-Benz B Electric Drive?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What tyre pressure should a Mercedes-Benz B Electric Drive use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation