Mega · Fourgon Vitre · PSI

What PSI for a Mega Fourgon Vitre?

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If a Fourgon Vitre owner asks “what PSI?”, start at 34 at the steering axle and 34 at the rear, then confirm the placard. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Mega tyre.

Mega Fourgon Vitre placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Fourgon Vitre is the pillar sticker, near 34/34 psi.

PSI, bar and kPa

PSI-led conversions for the Mega Fourgon Vitre band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Estimated pressure by tyre size (225/50R17 and others)

If your Mega Fourgon Vitre no longer wears the OEM diameter, start at the row nearest 225/50R17 or 185/65R15 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch
185/65R15	33	33	2.28	2.28	228	228	Small / older car
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
225/40R18	36	36	2.48	2.48	248	248	Low-profile 18-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch

How to set the Fourgon Vitre

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep Fourgon Vitre numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	38 psi / 2.62 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Fourgon Vitre.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Mega notes

No special Mega exception: the Fourgon Vitre uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Mega Fourgon Vitre usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Fourgon Vitre than nitrogen upsells.

Other Mega models

Maxi Concept Cabriolet Club Break

Questions about this Fourgon Vitre

What is that in bar and kPa for the Fourgon Vitre?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

How often should I check a Fourgon Vitre?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Front versus rear on the Mega Fourgon Vitre?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Mega Fourgon Vitre use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a Mega Fourgon Vitre?

No. Sidewall PSI is a maximum. The Fourgon Vitre placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation