UK · EU reference Tyre Pressure

Lexus · LM · Rear

Lexus LM rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Lexus LM is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 205/55R16, 245/40R18 and 185/65R15 — interpolated from the catalogue midpoint, not a second factory sticker.

Lexus LM placard versus sidewall

If the Lexus sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (205/55R16 and others)

205/55R16 is the first planning size here. 185/65R15 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R16342.34234Typical mid-compact OEM
245/40R18362.48248Wide touring 18-inch
185/65R15332.28228Small / older car
225/45R17352.41241Sport 17-inch
225/50R17352.41241Touring 17-inch
205/60R16342.34234Taller 16-inch
215/55R16352.41241Slightly wider 16-inch
195/65R15342.34234Very common compact

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar38 psi / 2.62 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this LM.

How to set the LM

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep LM numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Lexus LM band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this LM.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Lexus notes

No special Lexus exception: the LM uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Lexus LM usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Lexus sticker and this page disagree, the sticker wins.

Other Lexus models

Questions about this LM

What is that in bar and kPa for the LM?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Lexus LM?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Lexus LM?

No. Sidewall PSI is a maximum. The LM placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Lexus LM use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 185/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/55R16, 245/40R18 and 185/65R15 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation