UK · EU reference Tyre Pressure

LDV · Maxus · PSI

LDV Maxus tyre PSI

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A LDV Maxus run at sidewall-max (often 44–51 psi) is over-inflated for this passenger car. The operating PSI is 32-35/32-35. Size estimates on this page include 215/55R16, 225/40R18 and 245/40R18 — interpolated from the catalogue midpoint, not a second factory sticker.

LDV Maxus placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Maxus is the pillar sticker, near 34/34 psi.

PSI, bar and kPa

PSI-led conversions for the LDV Maxus band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (215/55R16 and others)

If your LDV Maxus no longer wears the OEM diameter, start at the row nearest 215/55R16 or 225/40R18 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/55R1634352.342.41234241Slightly wider 16-inch
225/40R1836362.482.48248248Low-profile 18-inch
245/40R1836362.482.48248248Wide touring 18-inch
205/55R1634342.342.34234234Typical mid-compact OEM
185/65R1533332.282.28228228Small / older car
195/65R1534342.342.34234234Very common compact
205/60R1634342.342.34234234Taller 16-inch
225/45R1735352.412.41241241Sport 17-inch

How to set the Maxus

  1. Park the LDV Maxus for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Maxus is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Maxus.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

LDV notes

No special LDV exception: the Maxus uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the LDV Maxus usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the LDV sticker and this page disagree, the sticker wins.

Other LDV models

Questions about this Maxus

Front versus rear on the LDV Maxus?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a LDV Maxus?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What tyre pressure should a LDV Maxus use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a LDV Maxus?

No. Sidewall PSI is a maximum. The Maxus placard is the operating target, near 32-35/32-35 psi.

What PSI if I plus-size toward 245/40R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/55R16, 225/40R18 and 245/40R18 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation