Land Rover · Range Rover Velar · Bar

Recommended bar for a Land Rover Range Rover Velar

Drivetrain: four-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this Range Rover Velar 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Keep side-to-side spread inside about 2 psi so the four-wheel drive hardware is not working on a radius mismatch.

Bar, PSI and kPa

Bar-led conversions around the Land Rover Range Rover Velar. 2.2-2.4 bar is not “32-35 divided by ten”.

Bar	PSI	kPa
2.07	30	207
2.21	32	221
2.28	33	228
2.31	33.5	231
2.41	35	241
2.48	36	248
2.62	38	262
2.76	40	276
3.03	44	303
3.45	50	345
4.14	60	414

Land Rover Range Rover Velar placard versus sidewall

If the Land Rover sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (185/65R15 and others)

185/65R15 is the first planning size here. 195/65R15 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
185/65R15	33	33	2.28	2.28	228	228	Small / older car
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
195/65R15	34	34	2.34	2.34	234	234	Very common compact
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	37 psi / 2.55 bar

How to set the Range Rover Velar

Park the Land Rover Range Rover Velar for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a four-wheel drive Range Rover Velar is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Range Rover Velar.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Land Rover notes

Land Rover 4x4s may list terrain programmes. Highway pressure is still the placard; airing down off-road is temporary.

Spare and inflator kit

A matching full-size spare on the Land Rover Range Rover Velar usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Land Rover Range Rover Velar on the printed band; use 185/65R15 and 195/65R15 only as a map for non-OEM wheels.

Other Land Rover models

Freelander Range Rover Range Rover Sport Range Rover Evoque Series Discovery LRX Discovery Sport

Questions about this Range Rover Velar

When does TPMS warn on a Land Rover Range Rover Velar?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Front versus rear on the Land Rover Range Rover Velar?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Is the sidewall number correct on a Land Rover Range Rover Velar?

No. Sidewall PSI is a maximum. The Range Rover Velar placard is the operating target, near 32-35/32-35 psi.

How often should I check a Range Rover Velar?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Handbook: placard · bar vs PSI · front vs rear · cold inflation