UK · EU reference Tyre Pressure

Land Rover · Discovery · Recommended

Land Rover Discovery recommended cold inflation

Drivetrain
all-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Treat this page as a map of the Discovery band. The legal setpoint is the printed door-pillar label for your VIN. Under-inflation cooks the shoulders of a Discovery; over-inflation wears the centre rib and bangs every cat’s eye. Keep side-to-side spread inside about 2 psi so the all-wheel drive hardware is not working on a radius mismatch.

How to set the Discovery

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Discovery numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Land Rover Discovery placard versus sidewall

The tyre-information placard on a Land Rover Discovery sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (235/65R17 and others)

235/65R17 is the first planning size here. 255/50R20 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/65R1735362.412.48241248Mid-size SUV
245/55R1936362.482.48248248Low-profile 19-inch
255/50R2037372.552.5525525520-inch plus-size
235/60R1836362.482.48248248Plus-size 18-inch
225/60R1835352.412.41241241Highway CUV
215/70R1634342.342.34234234Compact crossover
245/60R1836372.482.55248255Heavier CUV
225/65R1735352.412.41241241Very common 17-inch

PSI, bar and kPa

PSI-led conversions for the Land Rover Discovery band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Discovery.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Land Rover notes

Land Rover 4x4s may list terrain programmes. Highway pressure is still the placard; airing down off-road is temporary.

Spare and inflator kit

A matching full-size spare on the Land Rover Discovery usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Land Rover sticker and this page disagree, the sticker wins.

Other Land Rover models

Questions about this Discovery

What is that in bar and kPa for the Discovery?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Land Rover Discovery?

No. Sidewall PSI is a maximum. The Discovery placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Land Rover Discovery use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 255/50R20?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 235/65R17, 245/55R19 and 255/50R20 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation