UK · EU reference Tyre Pressure

Lada · Natacha · Rear

Lada Natacha rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Lada Natacha is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 215/50R17, 225/45R17 and 225/50R17 — interpolated from the catalogue midpoint, not a second factory sticker.

Lada Natacha placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Natacha is the pillar sticker, near 34/34 psi.

Estimated pressure by tyre size (215/50R17 and others)

If your Lada Natacha no longer wears the OEM diameter, start at the row nearest 215/50R17 or 225/45R17 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R17352.41241Plus-size 17-inch
225/45R17352.41241Sport 17-inch
225/50R17352.41241Touring 17-inch
215/55R16352.41241Slightly wider 16-inch
245/40R18362.48248Wide touring 18-inch
185/65R15332.28228Small / older car
205/60R16342.34234Taller 16-inch
195/65R15342.34234Very common compact

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this Natacha.

How to set the Natacha

  1. Park the Lada Natacha for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Natacha is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Lada Natacha band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Natacha.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Lada notes

No special Lada exception: the Natacha uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Lada Natacha usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Lada sticker and this page disagree, the sticker wins.

Other Lada models

Questions about this Natacha

What is that in bar and kPa for the Natacha?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Lada Natacha?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

How often should I check a Natacha?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What PSI if I plus-size toward 225/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/50R17, 225/45R17 and 225/50R17 as a planning band.

What tyre pressure should a Lada Natacha use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation