UK · EU reference Tyre Pressure

Lada · 1200 · PSI

Lada 1200 inflation in PSI (32-35 front, 32-35 rear)

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A Lada 1200 run at sidewall-max (often 44–51 psi) is over-inflated for this passenger car. The operating PSI is 32-35/32-35. Size estimates on this page include 245/40R18, 195/65R15 and 215/50R17 — interpolated from the catalogue midpoint, not a second factory sticker.

Lada 1200 placard versus sidewall

The tyre-information placard on a Lada 1200 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

PSI, bar and kPa

PSI-led conversions for the Lada 1200 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (245/40R18 and others)

245/40R18 is the first planning size here. 215/50R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
245/40R1836362.482.48248248Wide touring 18-inch
195/65R1534342.342.34234234Very common compact
215/50R1735352.412.41241241Plus-size 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
225/45R1735352.412.41241241Sport 17-inch
185/65R1533332.282.28228228Small / older car
205/60R1634342.342.34234234Taller 16-inch
205/55R1634342.342.34234234Typical mid-compact OEM

How to set the 1200

  1. Park the Lada 1200 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive 1200 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 1200.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Lada notes

No special Lada exception: the 1200 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Lada 1200 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Lada sticker and this page disagree, the sticker wins.

Other Lada models

Questions about this 1200

Front versus rear on the Lada 1200?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 215/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/40R18, 195/65R15 and 215/50R17 as a planning band.

Is the sidewall number correct on a Lada 1200?

No. Sidewall PSI is a maximum. The 1200 placard is the operating target, near 32-35/32-35 psi.

What is that in bar and kPa for the 1200?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation