UK · EU reference Tyre Pressure

JAC · JS7 · Rear

JAC JS7 rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Loaded JS7 rears often need the sticker’s second column, not a copy of the front 32-35 psi figure. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed JAC tyre.

JAC JS7 placard versus sidewall

If the JAC sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (225/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This JS7 sample opens with 225/40R18, then 205/55R16 and 185/65R15.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/40R18362.48248Low-profile 18-inch
205/55R16342.34234Typical mid-compact OEM
185/65R15332.28228Small / older car
245/40R18362.48248Wide touring 18-inch
215/55R16352.41241Slightly wider 16-inch
225/45R17352.41241Sport 17-inch
215/50R17352.41241Plus-size 17-inch
195/65R15342.34234Very common compact

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this JS7.

How to set the JS7

  1. Park the JAC JS7 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive JS7 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the JAC JS7 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this JS7.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

JAC notes

No special JAC exception: the JS7 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the JAC JS7 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the JAC JS7 on the printed band; use 225/40R18 and 185/65R15 only as a map for non-OEM wheels.

Other JAC models

Questions about this JS7

How often should I check a JS7?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a JAC JS7 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

When does TPMS warn on a JAC JS7?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Front versus rear on the JAC JS7?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 185/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/40R18, 205/55R16 and 185/65R15 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation