UK · EU reference Tyre Pressure

Ford · Transit Bus · kPa

276 kPa front, 379 kPa rear — Ford Transit Bus

Drivetrain
front-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

kPa

276 / 379

2.76 / 3.79 bar · 35-45 / 45-65 psi

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

If your gauge only speaks kPa, aim near 276 / 379 for this Transit Bus, then fine-tune to the placard. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Ford tyre. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as 215/75R16C are not filled like a Fiesta.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this Transit Bus sticker uses SI units.

kPaBarPSI
2412.4135
2482.4836
2622.6238
2762.7640
3033.0344
3103.1045
3453.4550
3793.7955
4144.1460
4484.4865

Estimated pressure by tyre size (215/65R16 and others)

215/65R16 is the first planning size here. 215/75R16C is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/65R1640572.763.93276393Compact van
235/65R1642592.94.07290407Loaded van
215/75R16C45643.14.41310441C-type 215
225/65R1641582.834283400Common transaxle van
LT215/85R1646653.174.48317448LT commercial
195/75R16C44633.034.34303434C-type commercial
235/60R1741582.834283400Plus-size van
225/75R1642602.94.14290414Taller load range

Ford Transit Bus placard versus sidewall

The tyre-information placard on a Ford Transit Bus sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 35-45 / 45-65 psi.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Transit Bus.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

How to set the Transit Bus

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Transit Bus numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy40 psi / 2.76 bar56 psi / 3.86 bar
Payload / towing41 psi / 2.83 bar57 psi / 3.93 bar

Ford notes

Ford UK placards on the Transit Bus are often printed in PSI even when the handbook also shows bar. A Mondeo, Focus or Kuga does not share a Transit number. Loaded vans use the second column.

Spare and inflator kit

A matching full-size spare on the Ford Transit Bus usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Ford Transit Bus on the printed band; use 215/65R16 and 215/75R16C only as a map for non-OEM wheels.

Other Ford models

Questions about this Transit Bus

What is that in bar and kPa for the Transit Bus?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

What PSI if I plus-size toward 215/75R16C?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/65R16, 235/65R16 and 215/75R16C as a planning band.

Is the sidewall number correct on a Ford Transit Bus?

No. Sidewall PSI is a maximum. The Transit Bus placard is the operating target, near 35-45/45-65 psi.

Front versus rear on the Ford Transit Bus?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Ford Transit Bus use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation