UK · EU reference Tyre Pressure

Ford · Probe · Overview

Tyre pressure chart for the Ford Probe

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The Ford Probe catalogue band is 32-35 psi front and 32-35 psi rear — 2.2-2.4 / 2.2-2.4 bar, or about 231 / 231 kPa — measured cold. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Spare and inflator kit

A matching full-size spare on the Ford Probe usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

Ford notes

Ford UK placards on the Probe are often printed in PSI even when the handbook also shows bar. A Mondeo, Focus or Kuga does not share a Transit number. Loaded vans use the second column.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Probe: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Probe.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Probe

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Probe numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Ford Probe placard versus sidewall

If the Ford sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (195/65R15 and others)

If your Ford Probe no longer wears the OEM diameter, start at the row nearest 195/65R15 or 205/60R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
195/65R1534342.342.34234234Very common compact
205/60R1634342.342.34234234Taller 16-inch
215/50R1735352.412.41241241Plus-size 17-inch
225/40R1836362.482.48248248Low-profile 18-inch
215/55R1634352.342.41234241Slightly wider 16-inch
245/40R1836362.482.48248248Wide touring 18-inch
225/45R1735352.412.41241241Sport 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM

Keep the Ford Probe on the printed band; use 195/65R15 and 215/50R17 only as a map for non-OEM wheels.

Other Ford models

Questions about this Probe

Front versus rear on the Ford Probe?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Ford Probe?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Ford Probe?

No. Sidewall PSI is a maximum. The Probe placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Ford Probe use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 215/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 195/65R15, 205/60R16 and 215/50R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation