UK · EU reference Tyre Pressure

Ford · E-Transit · Rear

Ford E-Transit rear tyre pressure

Drivetrain
front-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi rear

55

3.79 bar · 379 kPa at the rear axle

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

Loaded E-Transit rears often need the sticker’s second column, not a copy of the front 35-45 psi figure. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Ford tyre. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as LT215/85R16 are not filled like a Fiesta.

Ford E-Transit placard versus sidewall

If the Ford sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (195/75R16C and others)

Planning cold pressures for sizes often seen on a van. This E-Transit sample opens with 195/75R16C, then 215/75R16C and LT215/85R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
195/75R16C634.34434C-type commercial
215/75R16C644.41441C-type 215
LT215/85R16654.48448LT commercial
225/65R16584400Common transaxle van
225/75R16604.14414Taller load range
235/60R17584400Plus-size van
215/65R16573.93393Compact van
235/65R16594.07407Loaded van

Pressure against load

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy40 psi / 2.76 bar56 psi / 3.86 bar
Payload / towing41 psi / 2.83 bar59 psi / 4.07 bar

A family van with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this E-Transit.

How to set the E-Transit

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep E-Transit numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Ford E-Transit band (35-45 / 45-65).

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this E-Transit.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Ford notes

Ford UK placards on the E-Transit are often printed in PSI even when the handbook also shows bar. A Mondeo, Focus or Kuga does not share a Transit number. Loaded vans use the second column.

Spare and inflator kit

A matching full-size spare on the Ford E-Transit usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Ford sticker and this page disagree, the sticker wins.

Other Ford models

Questions about this E-Transit

What is that in bar and kPa for the E-Transit?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

What PSI if I plus-size toward LT215/85R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 195/75R16C, 215/75R16C and LT215/85R16 as a planning band.

How often should I check a E-Transit?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Is the sidewall number correct on a Ford E-Transit?

No. Sidewall PSI is a maximum. The E-Transit placard is the operating target, near 35-45/45-65 psi.

What tyre pressure should a Ford E-Transit use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation