UK · EU reference Tyre Pressure

Fiat · Maxi · Recommended

Fiat Maxi recommended cold inflation

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Recommended pressure means the vehicle placard, not the tyre sidewall. For a Fiat Maxi the catalogue proxy is 32-35/32-35 psi (2.2-2.4/2.2-2.4 bar). Size estimates on this page include 205/55R16, 225/45R17 and 215/55R16 — interpolated from the catalogue midpoint, not a second factory sticker.

How to set the Maxi

  1. Park the Fiat Maxi for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Maxi is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Fiat Maxi placard versus sidewall

The tyre-information placard on a Fiat Maxi sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (205/55R16 and others)

Planning cold pressures for sizes often seen on a passenger car. This Maxi sample opens with 205/55R16, then 225/45R17 and 215/55R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R1634342.342.34234234Typical mid-compact OEM
225/45R1735352.412.41241241Sport 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
195/65R1534342.342.34234234Very common compact
245/40R1836362.482.48248248Wide touring 18-inch
185/65R1533332.282.28228228Small / older car
225/50R1735352.412.41241241Touring 17-inch
215/50R1735352.412.41241241Plus-size 17-inch

PSI, bar and kPa

PSI-led conversions for the Fiat Maxi band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Maxi.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Fiat notes

No special Fiat exception: the Maxi uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Fiat Maxi usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Fiat sticker and this page disagree, the sticker wins.

Other Fiat models

Questions about this Maxi

Front versus rear on the Fiat Maxi?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 215/55R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/55R16, 225/45R17 and 215/55R16 as a planning band.

When does TPMS warn on a Fiat Maxi?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is that in bar and kPa for the Maxi?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation