UK · EU reference Tyre Pressure

Ferrari · F512 M · Front

Ferrari F512 M front tyre pressure

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi front

34

2.31 bar · 231 kPa at the steering axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A 3 psi miss on one front corner of this F512 M shows up as a wander before the TPMS lamp bothers you. Target 34 psi (2.31 bar) cold. Under-inflation cooks the shoulders of a F512 M; over-inflation wears the centre rib and bangs every cat’s eye.

Ferrari F512 M placard versus sidewall

The tyre-information placard on a Ferrari F512 M sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (245/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This F512 M sample opens with 245/40R18, then 215/50R17 and 225/50R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
245/40R18362.48248Wide touring 18-inch
215/50R17352.41241Plus-size 17-inch
225/50R17352.41241Touring 17-inch
205/60R16342.34234Taller 16-inch
225/45R17352.41241Sport 17-inch
215/55R16342.34234Slightly wider 16-inch
205/55R16342.34234Typical mid-compact OEM
185/65R15332.28228Small / older car

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Steering feel on the F512 M lives on this axle. Do not drop front pressure to “soften” a plus-size 225/50R17; you will roll the sidewall in a roundabout.

How to set the F512 M

  1. Park the Ferrari F512 M for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a rear-wheel drive F512 M is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Ferrari F512 M band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this F512 M.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Ferrari notes

No special Ferrari exception: the F512 M uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Ferrari F512 M usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this F512 M than nitrogen upsells.

Other Ferrari models

Questions about this F512 M

What tyre pressure should a Ferrari F512 M use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 225/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/40R18, 215/50R17 and 225/50R17 as a planning band.

Front versus rear on the Ferrari F512 M?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Ferrari F512 M?

No. Sidewall PSI is a maximum. The F512 M placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation