UK · EU reference Tyre Pressure

DR Automobiles · DR7.0 · Rear

DR Automobiles DR7.0 rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Loaded DR7.0 rears often need the sticker’s second column, not a copy of the front 32-35 psi figure. Under-inflation cooks the shoulders of a DR7.0; over-inflation wears the centre rib and bangs every cat’s eye.

DR Automobiles DR7.0 placard versus sidewall

The tyre-information placard on a DR Automobiles DR7.0 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (225/45R17 and others)

Planning cold pressures for sizes often seen on a passenger car. This DR7.0 sample opens with 225/45R17, then 205/55R16 and 205/60R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/45R17352.41241Sport 17-inch
205/55R16342.34234Typical mid-compact OEM
205/60R16342.34234Taller 16-inch
215/55R16352.41241Slightly wider 16-inch
225/50R17352.41241Touring 17-inch
185/65R15332.28228Small / older car
195/65R15342.34234Very common compact
245/40R18362.48248Wide touring 18-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this DR7.0.

How to set the DR7.0

  1. Park the DR Automobiles DR7.0 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive DR7.0 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the DR Automobiles DR7.0 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this DR7.0.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

DR Automobiles notes

No special DR Automobiles exception: the DR7.0 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the DR Automobiles DR7.0 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the DR Automobiles sticker and this page disagree, the sticker wins.

Other DR Automobiles models

Questions about this DR7.0

What is that in bar and kPa for the DR7.0?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a DR Automobiles DR7.0?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a DR Automobiles DR7.0?

No. Sidewall PSI is a maximum. The DR7.0 placard is the operating target, near 32-35/32-35 psi.

How often should I check a DR7.0?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a DR Automobiles DR7.0 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation