UK · EU reference Tyre Pressure

DR Automobiles · City Cross · Cold

Setting cold tyres on a DR Automobiles City Cross

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

UK winter mornings will show a lower gauge on this City Cross without a puncture. Set 34/34 psi at ~20 °C equivalent, not after a motorway blast. Under-inflation cooks the shoulders of a City Cross; over-inflation wears the centre rib and bangs every cat’s eye.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this City Cross.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the City Cross

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep City Cross numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

DR Automobiles City Cross placard versus sidewall

If the DR Automobiles sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (205/60R16 and others)

Planning cold pressures for sizes often seen on a passenger car. This City Cross sample opens with 205/60R16, then 225/40R18 and 245/40R18.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/60R1634342.342.34234234Taller 16-inch
225/40R1836362.482.48248248Low-profile 18-inch
245/40R1836362.482.48248248Wide touring 18-inch
225/45R1735352.412.41241241Sport 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
225/50R1735352.412.41241241Touring 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
195/65R1534342.342.34234234Very common compact

PSI, bar and kPa

PSI-led conversions for the DR Automobiles City Cross band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

DR Automobiles notes

No special DR Automobiles exception: the City Cross uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the DR Automobiles City Cross usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this City Cross than nitrogen upsells.

Other DR Automobiles models

Questions about this City Cross

What tyre pressure should a DR Automobiles City Cross use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is that in bar and kPa for the City Cross?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a DR Automobiles City Cross?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What PSI if I plus-size toward 245/40R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/60R16, 225/40R18 and 245/40R18 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation