UK · EU reference Tyre Pressure

Dangel · Ducato · Bar

Recommended bar for a Dangel Ducato

Drivetrain
front-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

bar

2.76 / 3.79

35-45 / 45-65 psi · 276 / 379 kPa

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

2.3 bar is not 23 psi. On this Ducato 2.4-3.1 bar converts to about 35-45 psi. Use the table, not a guess. Size estimates on this page include 235/60R17, 215/65R16 and 215/75R16C — interpolated from the catalogue midpoint, not a second factory sticker. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as 215/75R16C are not filled like a Fiesta.

Bar, PSI and kPa

Bar-led conversions around the Dangel Ducato. 2.4-3.1 bar is not “35-45 divided by ten”.

BarPSIkPa
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.1045310
3.4550345
3.7955379
4.1460414
4.4865448

Dangel Ducato placard versus sidewall

If the Dangel sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (235/60R17 and others)

235/60R17 is the first planning size here. 215/75R16C is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/60R1741582.834283400Plus-size van
215/65R1640572.763.93276393Compact van
215/75R16C45643.14.41310441C-type 215
LT215/85R1646653.174.48317448LT commercial
195/75R16C44633.034.34303434C-type commercial
225/75R1642602.94.14290414Taller load range
225/65R1641582.834283400Common transaxle van
235/65R1642592.94.07290407Loaded van

Load notes

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Payload / towing42 psi / 2.9 bar59 psi / 4.07 bar

How to set the Ducato

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Ducato numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Ducato.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Dangel notes

No special Dangel exception: the Ducato uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Dangel Ducato usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Ducato than nitrogen upsells.

Other Dangel models

Questions about this Ducato

What tyre pressure should a Dangel Ducato use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

How often should I check a Ducato?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What PSI if I plus-size toward 215/75R16C?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 235/60R17, 215/65R16 and 215/75R16C as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Dangel Ducato?

No. Sidewall PSI is a maximum. The Ducato placard is the operating target, near 35-45/45-65 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation