Bedford · Rascal · Recommended

Recommended tyre pressure for a Bedford Rascal

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Recommended pressure means the vehicle placard, not the tyre sidewall. For a Bedford Rascal the catalogue proxy is 32-35/32-35 psi (2.2-2.4/2.2-2.4 bar). Size estimates on this page include 225/50R17, 195/65R15 and 215/55R16 — interpolated from the catalogue midpoint, not a second factory sticker.

How to set the Rascal

Park the Bedford Rascal for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a front-wheel drive Rascal is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

Bedford Rascal placard versus sidewall

The tyre-information placard on a Bedford Rascal sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (225/50R17 and others)

If your Bedford Rascal no longer wears the OEM diameter, start at the row nearest 225/50R17 or 195/65R15 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch
195/65R15	34	34	2.34	2.34	234	234	Very common compact
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
185/65R15	33	33	2.28	2.28	228	228	Small / older car

PSI, bar and kPa

PSI-led conversions for the Bedford Rascal band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Rascal.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Bedford notes

No special Bedford exception: the Rascal uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Bedford Rascal usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Bedford sticker and this page disagree, the sticker wins.

Other Bedford models

CA HA Dormobile Blitz CF2 Midi Beagle TJ

Questions about this Rascal

Front versus rear on the Bedford Rascal?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Bedford Rascal use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

How often should I check a Rascal?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Is the sidewall number correct on a Bedford Rascal?

No. Sidewall PSI is a maximum. The Rascal placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation