UK · EU reference Tyre Pressure

Audi · A6 e-tron · Rear

Rear axle PSI and bar on the Audi A6 e-tron

Drivetrain
all-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Audi A6 e-tron is 32-35 psi / 2.2-2.4 bar. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Battery mass on this {make} {model} makes a 4 psi-low tyre cost range as well as heat.

Audi A6 e-tron placard versus sidewall

The tyre-information placard on a Audi A6 e-tron sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (215/50R17 and others)

Planning cold pressures for sizes often seen on a passenger car. This A6 e-tron sample opens with 215/50R17, then 235/45R18 and 245/40R18.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R17352.41241Plus-size 17-inch
235/45R18362.48248Common EV 18-inch
245/40R18362.48248Wide touring 18-inch
205/55R16342.34234Typical mid-compact OEM
205/60R16342.34234Taller 16-inch
195/65R15342.34234Very common compact
215/55R16352.41241Slightly wider 16-inch
225/45R17352.41241Sport 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this A6 e-tron.

How to set the A6 e-tron

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep A6 e-tron numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Audi A6 e-tron band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this A6 e-tron.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Audi notes

No special Audi exception: the A6 e-tron uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Audi A6 e-tron usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Audi A6 e-tron on the printed band; use 215/50R17 and 245/40R18 only as a map for non-OEM wheels.

Other Audi models

Questions about this A6 e-tron

Front versus rear on the Audi A6 e-tron?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Audi A6 e-tron?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Audi A6 e-tron?

No. Sidewall PSI is a maximum. The A6 e-tron placard is the operating target, near 32-35/32-35 psi.

What PSI if I plus-size toward 245/40R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/50R17, 235/45R18 and 245/40R18 as a planning band.

What is that in bar and kPa for the A6 e-tron?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation