UK · EU reference Tyre Pressure

Alfa Romeo · 8C · Front

Alfa Romeo 8C front tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi front

34

2.31 bar · 231 kPa at the steering axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A 3 psi miss on one front corner of this 8C shows up as a wander before the TPMS lamp bothers you. Target 34 psi (2.31 bar) cold. Under-inflation cooks the shoulders of a 8C; over-inflation wears the centre rib and bangs every cat’s eye.

Alfa Romeo 8C placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this 8C is the pillar sticker, near 34/34 psi.

Estimated pressure by tyre size (185/65R15 and others)

Planning cold pressures for sizes often seen on a passenger car. This 8C sample opens with 185/65R15, then 215/50R17 and 225/40R18.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
185/65R15332.28228Small / older car
215/50R17352.41241Plus-size 17-inch
225/40R18362.48248Low-profile 18-inch
245/40R18362.48248Wide touring 18-inch
225/50R17352.41241Touring 17-inch
205/55R16342.34234Typical mid-compact OEM
215/55R16342.34234Slightly wider 16-inch
225/45R17352.41241Sport 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Steering feel on the 8C lives on this axle. Do not drop front pressure to “soften” a plus-size 225/40R18; you will roll the sidewall in a roundabout.

How to set the 8C

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep 8C numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Alfa Romeo 8C band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 8C.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Alfa Romeo notes

No special Alfa Romeo exception: the 8C uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Alfa Romeo 8C usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Alfa Romeo 8C on the printed band; use 185/65R15 and 225/40R18 only as a map for non-OEM wheels.

Other Alfa Romeo models

Questions about this 8C

What is that in bar and kPa for the 8C?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

How often should I check a 8C?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

When does TPMS warn on a Alfa Romeo 8C?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Alfa Romeo 8C use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation