UK · EU reference Tyre Pressure

Alfa Romeo · 33 · Rear

Alfa Romeo 33 rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Loaded 33 rears often need the sticker’s second column, not a copy of the front 32-35 psi figure. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Alfa Romeo tyre.

Alfa Romeo 33 placard versus sidewall

The tyre-information placard on a Alfa Romeo 33 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (215/55R16 and others)

If your Alfa Romeo 33 no longer wears the OEM diameter, start at the row nearest 215/55R16 or 205/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/55R16352.41241Slightly wider 16-inch
205/55R16342.34234Typical mid-compact OEM
195/65R15342.34234Very common compact
225/50R17352.41241Touring 17-inch
225/45R17352.41241Sport 17-inch
225/40R18362.48248Low-profile 18-inch
185/65R15332.28228Small / older car
245/40R18362.48248Wide touring 18-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this 33.

How to set the 33

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep 33 numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Alfa Romeo 33 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 33.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Alfa Romeo notes

No special Alfa Romeo exception: the 33 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Alfa Romeo 33 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Alfa Romeo sticker and this page disagree, the sticker wins.

Other Alfa Romeo models

Questions about this 33

Front versus rear on the Alfa Romeo 33?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 195/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/55R16, 205/55R16 and 195/65R15 as a planning band.

When does TPMS warn on a Alfa Romeo 33?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Alfa Romeo 33?

No. Sidewall PSI is a maximum. The 33 placard is the operating target, near 32-35/32-35 psi.

What is that in bar and kPa for the 33?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation