UK · EU reference Tyre Pressure

245/50R18 · SUV / crossover · PSI

245/50R18 PSI chart (36 psi planning figure)

Size
245/50R18
Class
SUV / crossover
Planning PSI
36
Planning bar
2.48

psi

36

2.48 bar · 248 kPa · SUV / crossover planning figure

245/50R18 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

If someone typed “245/50R18 psi”, they want Imperial. Start near 36 psi on an unladen SUV / crossover, then confirm the vehicle placard. Sidewall max is not the target. Under-inflation cooks the shoulders of a 245/50R18; over-inflation wears the centre rib and bangs every cat’s eye.

Estimated 245/50R18 pressure by load

Load moves the rear first on a SUV / crossover. If the factory placard already has a laden column, use that — not this sketch for 245/50R18.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa38 psi / 2.62 bar / 262 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa39 psi / 2.69 bar / 269 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 245/50R18: 36 psi = 2.48 bar = 248 kPa.

PSIBarkPa
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331

What 245/50R18 means

245/50R18 means a 245 millimetre section width, a sidewall that is 50 percent of that width, on a 18-inch rim. The R is radial construction.

18-inch heavier CUV. Rim diameter 18 in; section 245 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

If a forum says “all 245/50R18 run 36 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Cars often seen on 245/50R18

These catalogue models are often seen on 245/50R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/50R18

  1. Park so the 245/50R18 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 245/50R18 sidewall maximum.
  3. If the sticker is missing, 36 psi / 2.48 bar is only a SUV / crossover planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 245/50R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 245/50R18
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 245/50R18

Keep 245/50R18 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.

Questions about 245/50R18

Can I run 245/50R18 at a lower pressure for comfort?

Not as a habit. A soft 245/50R18 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

When does TPMS warn on 245/50R18?

Direct TPMS typically flags about 25% below target — near 27 psi if you were aiming at 36. Fill to the sticker, not to the lamp.

What is 245/50R18 in kPa?

248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 245/50R18 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Handbook: placard · bar vs PSI · cold inflation · all sizes