235/35R19 · passenger car · Overview
235/35R19: PSI, bar and kPa
- Size
- 235/35R19
- Class
- passenger car
- Planning PSI
- 37
- Planning bar
- 2.55
235/35R19
37 psi / 2.55 bar
255 kPa · estimates for this size class
235/35R19 · 37 psi · 2.55 bar · 255 kPa — estimates. Placard wins.
235/35R19 is a passenger car size (235 mm section, 35 % aspect, 19-inch rim). A planning cold figure around 37 psi / 2.55 bar / 255 kPa is a starting map, not a second factory sticker. TPMS typically warns near 28 psi (about 25% below a 37 psi target). That is already a soft tyre. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.
What 235/35R19 means
Read 235/35R19 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.
Front 19-inch sport / EV. Rim diameter 19 in; section 235 mm. Estimates on this page assume a typical load index for the passenger car class.
Estimated 235/35R19 pressure by load
Plus-sizing to 235/35R19 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 37 psi / 2.55 bar / 255 kPa | 37 psi / 2.55 bar / 255 kPa |
| Typical occupancy | 37 psi / 2.55 bar / 255 kPa | 38 psi / 2.62 bar / 262 kPa |
| Motorway + luggage (sketch) | 38 psi / 2.62 bar / 262 kPa | 39 psi / 2.69 bar / 269 kPa |
PSI, bar and kPa
Use the table, then set a cold gauge. 255 kPa is 100 × 2.55 bar on this size.
| PSI | Bar | kPa |
|---|---|---|
| 33 | 2.28 | 228 |
| 34 | 2.34 | 234 |
| 35 | 2.41 | 241 |
| 36 | 2.48 | 248 |
| 37 | 2.55 | 255 |
| 38 | 2.62 | 262 |
| 39 | 2.69 | 269 |
| 40 | 2.76 | 276 |
| 41 | 2.83 | 283 |
| 42 | 2.90 | 290 |
| 43 | 2.96 | 296 |
| 44 | 3.03 | 303 |
| 45 | 3.10 | 310 |
| 46 | 3.17 | 317 |
| 47 | 3.24 | 324 |
| 48 | 3.31 | 331 |
| 49 | 3.38 | 338 |
Placard versus sidewall
This website maps size searches such as “235/35R19 psi”. It does not replace the VIN label. If the two disagree, the label wins.
Cars often seen on 235/35R19
These catalogue models are often seen on 235/35R19 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
How to set 235/35R19
- Park so the 235/35R19 tyres are cold (three hours, or less than about a mile).
- Read the door-pillar placard for that car — not the 235/35R19 sidewall maximum.
- If the sticker is missing, 37 psi / 2.55 bar is only a passenger car planning figure for this size.
- Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 37 psi as a 20 °C baseline for 235/35R19.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 34 psi | 2.34 bar | 234 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 35 psi | 2.41 bar | 241 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 36 psi | 2.48 bar | 248 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 37 psi | 2.55 bar | 255 kPa | Baseline for this size sketch |
| 30 °C | 39 psi | 2.69 bar | 269 kPa | Do not bleed a hot 235/35R19 |
| 38 °C (heatwave tarmac) | 40 psi | 2.76 bar | 276 kPa | Do not bleed a hot 235/35R19 |
A cheap gauge and a monthly habit will do more for a set of 235/35R19 than nitrogen upsells.
Questions about 235/35R19
Can I run 235/35R19 at a lower pressure for comfort?
Not as a habit. A soft 235/35R19 cooks the shoulders and dulls steering. Keep load index and stay on the placard.
What is 235/35R19 in bar?
37 psi is 2.55 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.
When does TPMS warn on 235/35R19?
Direct TPMS typically flags about 25% below target — near 28 psi if you were aiming at 37. Fill to the sticker, not to the lamp.
Is the sidewall number correct for 235/35R19?
No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.
What is 235/35R19 in kPa?
255 kPa is the planning midpoint (100 kPa = 1 bar). 262 kPa is one PSI higher.
Handbook: placard · bar vs PSI · cold inflation · all sizes