UK · EU reference Tyre Pressure

225/60R16 · SUV / crossover · PSI

225/60R16 PSI chart (34 psi planning figure)

Size
225/60R16
Class
SUV / crossover
Planning PSI
34
Planning bar
2.34

psi

34

2.34 bar · 234 kPa · SUV / crossover planning figure

225/60R16 · 34 psi · 2.34 bar · 234 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 225/60R16 a typical SUV / crossover planning figure is 34 psi cold — about 2.34 bar or 234 kPa. 16-inch CUV highway size. These rows are estimates interpolated for the size, not OEM for a named VIN.

Estimated 225/60R16 pressure by load

Plus-sizing to 225/60R16 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen34 psi / 2.34 bar / 234 kPa34 psi / 2.34 bar / 234 kPa
Typical occupancy34 psi / 2.34 bar / 234 kPa35 psi / 2.41 bar / 241 kPa
Motorway + luggage (sketch)35 psi / 2.41 bar / 241 kPa36 psi / 2.48 bar / 248 kPa

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 225/60R16: 34 psi = 2.34 bar = 234 kPa.

PSIBarkPa
302.07207
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317

What 225/60R16 means

A 225/60R16 on a SUV / crossover is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

16-inch CUV highway size. Rim diameter 16 in; section 225 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

If a forum says “all 225/60R16 run 34 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Cars often seen on 225/60R16

These catalogue models are often seen on 225/60R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 225/60R16

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 225/60R16 numbers in your head.
  3. Add air in short bursts toward the placard, using 34 psi only as a map.
  4. If one 225/60R16 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for 225/60R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline for this size sketch
30 °C36 psi2.48 bar248 kPaDo not bleed a hot 225/60R16
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot 225/60R16

Keep 225/60R16 on the printed band for that car; 34 psi is a size sketch, not a second VIN label.

Questions about 225/60R16

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

When does TPMS warn on 225/60R16?

Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 34. Fill to the sticker, not to the lamp.

Is 225/60R16 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

What is 225/60R16 in bar?

34 psi is 2.34 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

What PSI should 225/60R16 tyres be?

A SUV / crossover planning figure is about 34 psi cold (2.34 bar / 234 kPa). Confirm on the vehicle placard — two cars can share 225/60R16 and not share a sticker.

Handbook: placard · bar vs PSI · cold inflation · all sizes