215/55R17 · passenger car · Overview
Recommended pressure for 215/55R17 tyres
- Size
- 215/55R17
- Class
- passenger car
- Planning PSI
- 34
- Planning bar
- 2.34
215/55R17
34 psi / 2.34 bar
234 kPa · estimates for this size class
215/55R17 · 34 psi · 2.34 bar · 234 kPa — estimates. Placard wins.
215/55R17 is a passenger car size (215 mm section, 55 % aspect, 17-inch rim). A planning cold figure around 34 psi / 2.34 bar / 234 kPa is a starting map, not a second factory sticker. 17-inch family / CUV overlap. These rows are estimates interpolated for the size, not OEM for a named VIN.
What 215/55R17 means
Read 215/55R17 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.
17-inch family / CUV overlap. Rim diameter 17 in; section 215 mm. Estimates on this page assume a typical load index for the passenger car class.
Estimated 215/55R17 pressure by load
Plus-sizing to 215/55R17 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 34 psi / 2.34 bar / 234 kPa | 34 psi / 2.34 bar / 234 kPa |
| Typical occupancy | 34 psi / 2.34 bar / 234 kPa | 35 psi / 2.41 bar / 241 kPa |
| Motorway + luggage (sketch) | 35 psi / 2.41 bar / 241 kPa | 36 psi / 2.48 bar / 248 kPa |
PSI, bar and kPa
1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 215/55R17: 34 psi = 2.34 bar = 234 kPa.
| PSI | Bar | kPa |
|---|---|---|
| 30 | 2.07 | 207 |
| 31 | 2.14 | 214 |
| 32 | 2.21 | 221 |
| 33 | 2.28 | 228 |
| 34 | 2.34 | 234 |
| 35 | 2.41 | 241 |
| 36 | 2.48 | 248 |
| 37 | 2.55 | 255 |
| 38 | 2.62 | 262 |
| 39 | 2.69 | 269 |
| 40 | 2.76 | 276 |
| 41 | 2.83 | 283 |
| 42 | 2.90 | 290 |
| 43 | 2.96 | 296 |
| 44 | 3.03 | 303 |
| 45 | 3.10 | 310 |
| 46 | 3.17 | 317 |
Placard versus sidewall
This website maps size searches such as “215/55R17 psi”. It does not replace the VIN label. If the two disagree, the label wins.
Cars often seen on 215/55R17
These catalogue models are often seen on 215/55R17 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
How to set 215/55R17
- Park so the 215/55R17 tyres are cold (three hours, or less than about a mile).
- Read the door-pillar placard for that car — not the 215/55R17 sidewall maximum.
- If the sticker is missing, 34 psi / 2.34 bar is only a passenger car planning figure for this size.
- Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for 215/55R17.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 31 psi | 2.14 bar | 214 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 34 psi | 2.34 bar | 234 kPa | Baseline for this size sketch |
| 30 °C | 36 psi | 2.48 bar | 248 kPa | Do not bleed a hot 215/55R17 |
| 38 °C (heatwave tarmac) | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot 215/55R17 |
If the door sticker and this 215/55R17 page disagree, the sticker wins.
Questions about 215/55R17
What is 215/55R17 in kPa?
234 kPa is the planning midpoint (100 kPa = 1 bar). 241 kPa is one PSI higher.
What PSI should 215/55R17 tyres be?
A passenger car planning figure is about 34 psi cold (2.34 bar / 234 kPa). Confirm on the vehicle placard — two cars can share 215/55R17 and not share a sticker.
What is 215/55R17 in bar?
34 psi is 2.34 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.
Is 215/55R17 the same as a plus-size swap?
Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.
When does TPMS warn on 215/55R17?
Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 34. Fill to the sticker, not to the lamp.
Handbook: placard · bar vs PSI · cold inflation · all sizes