UK · EU reference Tyre Pressure

Westfield · 7SE · Overview

Westfield 7SE tyre pressure

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The Westfield 7SE catalogue band is 32-35 psi front and 32-35 psi rear — 2.2-2.4 / 2.2-2.4 bar, or about 231 / 231 kPa — measured cold. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 7SE.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Westfield notes

No special Westfield exception: the 7SE uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Westfield 7SE placard versus sidewall

If the Westfield sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Spare and inflator kit

A matching full-size spare on the Westfield 7SE usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the 7SE: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar38 psi / 2.62 bar

How to set the 7SE

  1. Park the Westfield 7SE for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive 7SE is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Estimated pressure by tyre size (215/55R16 and others)

If your Westfield 7SE no longer wears the OEM diameter, start at the row nearest 215/55R16 or 195/65R15 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/55R1634352.342.41234241Slightly wider 16-inch
195/65R1534342.342.34234234Very common compact
205/60R1634342.342.34234234Taller 16-inch
185/65R1533332.282.28228228Small / older car
205/55R1634342.342.34234234Typical mid-compact OEM
225/45R1735352.412.41241241Sport 17-inch
215/50R1735352.412.41241241Plus-size 17-inch
225/40R1836362.482.48248248Low-profile 18-inch

Keep the Westfield 7SE on the printed band; use 215/55R16 and 205/60R16 only as a map for non-OEM wheels.

Other Westfield models

Questions about this 7SE

How often should I check a 7SE?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

When does TPMS warn on a Westfield 7SE?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What is that in bar and kPa for the 7SE?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Front versus rear on the Westfield 7SE?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 205/60R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/55R16, 195/65R15 and 205/60R16 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation