UK · EU reference Tyre Pressure

Wartburg · 1000 · PSI

Wartburg 1000 inflation in PSI (32-35 front, 32-35 rear)

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If a 1000 owner asks “what PSI?”, start at 34 at the steering axle and 34 at the rear, then confirm the placard. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Wartburg 1000 placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this 1000 is the pillar sticker, near 34/34 psi.

PSI, bar and kPa

PSI-led conversions for the Wartburg 1000 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (195/65R15 and others)

Planning cold pressures for sizes often seen on a passenger car. This 1000 sample opens with 195/65R15, then 225/45R17 and 205/60R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
195/65R1534342.342.34234234Very common compact
225/45R1735352.412.41241241Sport 17-inch
205/60R1634342.342.34234234Taller 16-inch
225/40R1836362.482.48248248Low-profile 18-inch
225/50R1735352.412.41241241Touring 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
185/65R1533332.282.28228228Small / older car
215/55R1634352.342.41234241Slightly wider 16-inch

How to set the 1000

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep 1000 numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 1000.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Wartburg notes

No special Wartburg exception: the 1000 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Wartburg 1000 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Wartburg sticker and this page disagree, the sticker wins.

Other Wartburg models

Questions about this 1000

Front versus rear on the Wartburg 1000?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Wartburg 1000 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 205/60R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 195/65R15, 225/45R17 and 205/60R16 as a planning band.

When does TPMS warn on a Wartburg 1000?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Wartburg 1000?

No. Sidewall PSI is a maximum. The 1000 placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation