UK · EU reference Tyre Pressure

Tazzari EV · Zero Special Edition · kPa

231 kPa front, 231 kPa rear — Tazzari EV Zero Special Edition

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

kPa

231 / 231

2.31 / 2.31 bar · 32-35 / 32-35 psi

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If your gauge only speaks kPa, aim near 231 / 231 for this Zero Special Edition, then fine-tune to the placard. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Tazzari EV tyre. Battery mass on this {make} {model} makes a 4 psi-low tyre cost range as well as heat.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this Zero Special Edition sticker uses SI units.

kPaBarPSI
2072.0730
2212.2132
2282.2833
2312.3133.5
2412.4135
2482.4836
2622.6238
2762.7640
3033.0344
3453.4550
4144.1460

Estimated pressure by tyre size (225/50R17 and others)

If your Tazzari EV Zero Special Edition no longer wears the OEM diameter, start at the row nearest 225/50R17 or 215/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/50R1735352.412.41241241Touring 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
235/45R1836362.482.48248248Common EV 18-inch
215/50R1735352.412.41241241Plus-size 17-inch
195/65R1534342.342.34234234Very common compact
185/65R1533332.282.28228228Small / older car
225/45R1735352.412.41241241Sport 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM

Tazzari EV Zero Special Edition placard versus sidewall

The tyre-information placard on a Tazzari EV Zero Special Edition sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Zero Special Edition.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Zero Special Edition

  1. Park the Tazzari EV Zero Special Edition for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Zero Special Edition is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

Tazzari EV notes

No special Tazzari EV exception: the Zero Special Edition uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Tazzari EV Zero Special Edition usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Tazzari EV sticker and this page disagree, the sticker wins.

Other Tazzari EV models

Questions about this Zero Special Edition

When does TPMS warn on a Tazzari EV Zero Special Edition?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Front versus rear on the Tazzari EV Zero Special Edition?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Tazzari EV Zero Special Edition use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

How often should I check a Zero Special Edition?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Handbook: placard · bar vs PSI · front vs rear · cold inflation