Segway · Fugleman UT6 H · Cold

Setting cold tyres on a Segway Fugleman UT6 H

Drivetrain: front-wheel drive
Body: SUV / crossover
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Cold means the Segway Fugleman UT6 H has stood at least three hours, or covered less than about a mile. Heat from a dual carriageway run is not the number you set. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Fugleman UT6 H.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

How to set the Fugleman UT6 H

Park the Segway Fugleman UT6 H for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a front-wheel drive Fugleman UT6 H is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

Segway Fugleman UT6 H placard versus sidewall

The tyre-information placard on a Segway Fugleman UT6 H sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (245/55R19 and others)

If your Segway Fugleman UT6 H no longer wears the OEM diameter, start at the row nearest 245/55R19 or 245/60R18 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
245/55R19	36	36	2.48	2.48	248	248	Low-profile 19-inch
245/60R18	36	37	2.48	2.55	248	255	Heavier CUV
225/65R17	35	35	2.41	2.41	241	241	Very common 17-inch
255/50R20	37	37	2.55	2.55	255	255	20-inch plus-size
215/70R16	34	34	2.34	2.34	234	234	Compact crossover
225/60R18	35	35	2.41	2.41	241	241	Highway CUV
235/65R17	35	36	2.41	2.48	241	248	Mid-size SUV
235/60R18	36	36	2.48	2.48	248	248	Plus-size 18-inch

PSI, bar and kPa

PSI-led conversions for the Segway Fugleman UT6 H band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	37 psi / 2.55 bar

Segway notes

No special Segway exception: the Fugleman UT6 H uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Segway Fugleman UT6 H usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Segway sticker and this page disagree, the sticker wins.

Other Segway models

Fugleman 1000 Villain SX10 Villain 1000 SH Fugleman UT 10 Villain SX10 H Fugleman 570

Questions about this Fugleman UT6 H

When does TPMS warn on a Segway Fugleman UT6 H?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What is that in bar and kPa for the Fugleman UT6 H?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 225/65R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/55R19, 245/60R18 and 225/65R17 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

How often should I check a Fugleman UT6 H?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Handbook: placard · bar vs PSI · front vs rear · cold inflation