Segway · Fugleman 1000 · Rear
Segway Fugleman 1000 rear tyres: 32-35 psi / 2.2-2.4 bar
- Drivetrain
- front-wheel drive
- Body
- SUV / crossover
- PSI F / R
- 32-35 / 32-35
- Bar F / R
- 2.2-2.4 / 2.2-2.4
psi rear
34
2.31 bar · 231 kPa at the rear axle
32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa
The rear of a SUV / crossover takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Segway Fugleman 1000 is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 255/50R20, 225/65R17 and 215/70R16 — interpolated from the catalogue midpoint, not a second factory sticker.
Segway Fugleman 1000 placard versus sidewall
Sidewall PSI is a carcass maximum. Recommended operating pressure for this Fugleman 1000 is the pillar sticker, near 34/34 psi.
Estimated pressure by tyre size (255/50R20 and others)
If your Segway Fugleman 1000 no longer wears the OEM diameter, start at the row nearest 255/50R20 or 225/65R17 and confirm with the tyre maker’s load table.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 255/50R20 | — | 37 | — | 2.55 | — | 255 | 20-inch plus-size |
| 225/65R17 | — | 35 | — | 2.41 | — | 241 | Very common 17-inch |
| 215/70R16 | — | 34 | — | 2.34 | — | 234 | Compact crossover |
| 225/60R18 | — | 35 | — | 2.41 | — | 241 | Highway CUV |
| 245/55R19 | — | 36 | — | 2.48 | — | 248 | Low-profile 19-inch |
| 235/60R18 | — | 36 | — | 2.48 | — | 248 | Plus-size 18-inch |
| 245/60R18 | — | 37 | — | 2.55 | — | 255 | Heavier CUV |
| 235/65R17 | — | 36 | — | 2.48 | — | 248 | Mid-size SUV |
Pressure against load
Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 34 psi / 2.34 bar | 34 psi / 2.34 bar |
| Full occupancy | 34 psi / 2.34 bar | 35 psi / 2.41 bar |
| Motorway + luggage | 35 psi / 2.41 bar | 38 psi / 2.62 bar |
A family SUV / crossover with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this Fugleman 1000.
How to set the Fugleman 1000
- Measure before the school run, not after the M25.
- Write LF / RF / RR / RL. Do not keep Fugleman 1000 numbers in your head.
- Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
- If one corner is 4 psi down, hunt for a nail before you blame the weather.
- Log date, ambient temperature and the four readings.
PSI, bar and kPa
PSI-led conversions for the Segway Fugleman 1000 band (32-35 / 32-35).
| PSI | Bar | kPa |
|---|---|---|
| 30 | 2.07 | 207 |
| 32 | 2.21 | 221 |
| 33 | 2.28 | 228 |
| 33.5 | 2.31 | 231 |
| 35 | 2.41 | 241 |
| 36 | 2.48 | 248 |
| 38 | 2.62 | 262 |
| 40 | 2.76 | 276 |
| 44 | 3.03 | 303 |
| 50 | 3.45 | 345 |
| 60 | 4.14 | 414 |
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Fugleman 1000.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 31 psi | 2.14 bar | 214 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 34 psi | 2.34 bar | 234 kPa | Baseline |
| 30 °C | 36 psi | 2.48 bar | 248 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot tyre |
Segway notes
No special Segway exception: the Fugleman 1000 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.
Spare and inflator kit
A matching full-size spare on the Segway Fugleman 1000 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
If the Segway sticker and this page disagree, the sticker wins.
Other Segway models
Questions about this Fugleman 1000
What is that in bar and kPa for the Fugleman 1000?
Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.
When does TPMS warn on a Segway Fugleman 1000?
Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.
Is the sidewall number correct on a Segway Fugleman 1000?
No. Sidewall PSI is a maximum. The Fugleman 1000 placard is the operating target, near 32-35/32-35 psi.
Front versus rear on the Segway Fugleman 1000?
This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.
What tyre pressure should a Segway Fugleman 1000 use?
Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.
Handbook: placard · bar vs PSI · front vs rear · cold inflation