UK · EU reference Tyre Pressure

Santana · Vitara · Bar

Santana Vitara tyre pressure in bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A front-wheel drive Santana Vitara still wants even corners. 2.2-2.4 vs 2.2-2.4 is an axle split, not a left-right split. Under-inflation cooks the shoulders of a Vitara; over-inflation wears the centre rib and bangs every cat’s eye.

Bar, PSI and kPa

Bar-led conversions around the Santana Vitara. 2.2-2.4 bar is not “32-35 divided by ten”.

BarPSIkPa
2.0730207
2.2132221
2.2833228
2.3133.5231
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.4550345
4.1460414

Santana Vitara placard versus sidewall

If the Santana sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (215/50R17 and others)

215/50R17 is the first planning size here. 215/55R16 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R1735352.412.41241241Plus-size 17-inch
185/65R1533332.282.28228228Small / older car
215/55R1634352.342.41234241Slightly wider 16-inch
225/50R1735352.412.41241241Touring 17-inch
245/40R1836362.482.48248248Wide touring 18-inch
205/60R1634342.342.34234234Taller 16-inch
225/40R1836362.482.48248248Low-profile 18-inch
225/45R1735352.412.41241241Sport 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

How to set the Vitara

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Vitara numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Vitara.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Santana notes

No special Santana exception: the Vitara uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Santana Vitara usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Santana Vitara on the printed band; use 215/50R17 and 215/55R16 only as a map for non-OEM wheels.

Other Santana models

Questions about this Vitara

When does TPMS warn on a Santana Vitara?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

How often should I check a Vitara?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Front versus rear on the Santana Vitara?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 215/55R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/50R17, 185/65R15 and 215/55R16 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation