UK · EU reference Tyre Pressure

Ruf · 3600S · Overview

Ruf 3600S tyre pressure

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The Ruf 3600S catalogue band is 32-35 psi front and 32-35 psi rear — 2.2-2.4 / 2.2-2.4 bar, or about 231 / 231 kPa — measured cold. Size estimates on this page include 215/55R16, 185/65R15 and 205/60R16 — interpolated from the catalogue midpoint, not a second factory sticker.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the 3600S: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

How to set the 3600S

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep 3600S numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Ruf notes

No special Ruf exception: the 3600S uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 3600S.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Spare and inflator kit

A matching full-size spare on the Ruf 3600S usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Estimated pressure by tyre size (215/55R16 and others)

Planning cold pressures for sizes often seen on a passenger car. This 3600S sample opens with 215/55R16, then 185/65R15 and 205/60R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/55R1634352.342.41234241Slightly wider 16-inch
185/65R1533332.282.28228228Small / older car
205/60R1634342.342.34234234Taller 16-inch
195/65R1534342.342.34234234Very common compact
225/45R1735352.412.41241241Sport 17-inch
225/50R1735352.412.41241241Touring 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
215/50R1735352.412.41241241Plus-size 17-inch

Ruf 3600S placard versus sidewall

The tyre-information placard on a Ruf 3600S sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

If the Ruf sticker and this page disagree, the sticker wins.

Other Ruf models

Questions about this 3600S

What is that in bar and kPa for the 3600S?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 205/60R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/55R16, 185/65R15 and 205/60R16 as a planning band.

Is the sidewall number correct on a Ruf 3600S?

No. Sidewall PSI is a maximum. The 3600S placard is the operating target, near 32-35/32-35 psi.

Front versus rear on the Ruf 3600S?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Ruf 3600S use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation