Opel · Vivaro-e · Bar
Opel Vivaro-e tyre pressure in bar
- Drivetrain
- front-wheel drive
- Body
- van
- PSI F / R
- 35-45 / 45-65
- Bar F / R
- 2.4-3.1 / 3.1-4.5
bar
2.76 / 3.79
35-45 / 45-65 psi · 276 / 379 kPa
35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa
A front-wheel drive Opel Vivaro-e still wants even corners. 2.4-3.1 vs 3.1-4.5 is an axle split, not a left-right split. TPMS typically warns near 30 psi (about 25% below target). That is already a soft tyre, not a fill target. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as LT215/85R16 are not filled like a Fiesta.
Bar, PSI and kPa
Bar-led conversions around the Opel Vivaro-e. 2.4-3.1 bar is not “35-45 divided by ten”.
| Bar | PSI | kPa |
|---|---|---|
| 2.41 | 35 | 241 |
| 2.48 | 36 | 248 |
| 2.62 | 38 | 262 |
| 2.76 | 40 | 276 |
| 3.03 | 44 | 303 |
| 3.10 | 45 | 310 |
| 3.45 | 50 | 345 |
| 3.79 | 55 | 379 |
| 4.14 | 60 | 414 |
| 4.48 | 65 | 448 |
Opel Vivaro-e placard versus sidewall
The tyre-information placard on a Opel Vivaro-e sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 35-45 / 45-65 psi.
Estimated pressure by tyre size (225/75R16 and others)
225/75R16 is the first planning size here. LT215/85R16 is usually the plus-size or LT step. Keep load index at or above original equipment.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 225/75R16 | 42 | 60 | 2.9 | 4.14 | 290 | 414 | Taller load range |
| 215/65R16 | 40 | 57 | 2.76 | 3.93 | 276 | 393 | Compact van |
| LT215/85R16 | 46 | 65 | 3.17 | 4.48 | 317 | 448 | LT commercial |
| 225/65R16 | 41 | 58 | 2.83 | 4 | 283 | 400 | Common transaxle van |
| 235/60R17 | 41 | 58 | 2.83 | 4 | 283 | 400 | Plus-size van |
| 195/75R16C | 44 | 63 | 3.03 | 4.34 | 303 | 434 | C-type commercial |
| 215/75R16C | 45 | 64 | 3.1 | 4.41 | 310 | 441 | C-type 215 |
| 235/65R16 | 42 | 59 | 2.9 | 4.07 | 290 | 407 | Loaded van |
Load notes
Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 40 psi / 2.76 bar | 55 psi / 3.79 bar |
| Full occupancy | 40 psi / 2.76 bar | 56 psi / 3.86 bar |
| Payload / towing | 41 psi / 2.83 bar | 57 psi / 3.93 bar |
How to set the Vivaro-e
- Park the Opel Vivaro-e for at least three hours (cold tyres).
- Use a calibrated gauge, not the only meter on a forecourt hose.
- Set the placard for that axle — about 35-45 psi / 2.4-3.1 bar front and 45-65 psi / 3.1-4.5 bar rear on this catalogue row.
- Recheck all four. A 2 psi miss on a front-wheel drive Vivaro-e is enough to feel a pull.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Vivaro-e.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 37 psi | 2.55 bar | 255 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 38 psi | 2.62 bar | 262 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 39 psi | 2.69 bar | 269 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 40 psi | 2.76 bar | 276 kPa | Baseline |
| 30 °C | 42 psi | 2.9 bar | 290 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 43 psi | 2.96 bar | 296 kPa | Do not bleed a hot tyre |
Opel notes
No special Opel exception: the Vivaro-e uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.
Spare and inflator kit
A matching full-size spare on the Opel Vivaro-e usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
If the Opel sticker and this page disagree, the sticker wins.
Other Opel models
Questions about this Vivaro-e
What PSI if I plus-size toward LT215/85R16?
Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/75R16, 215/65R16 and LT215/85R16 as a planning band.
How often should I check a Vivaro-e?
Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.
When does TPMS warn on a Opel Vivaro-e?
Direct TPMS typically flags about 25% below placard — near 30 psi on this row. Fill to the sticker, not to the lamp.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
Is the sidewall number correct on a Opel Vivaro-e?
No. Sidewall PSI is a maximum. The Vivaro-e placard is the operating target, near 35-45/45-65 psi.
Handbook: placard · bar vs PSI · front vs rear · cold inflation