UK · EU reference Tyre Pressure

Oldtimer · Trident · Front

Oldtimer Trident front tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi front

34

2.31 bar · 231 kPa at the steering axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The front axle of a Oldtimer Trident steers and, on front-wheel drive cars, often pulls as well. Catalogue front pressure is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 205/60R16, 225/40R18 and 195/65R15 — interpolated from the catalogue midpoint, not a second factory sticker.

Oldtimer Trident placard versus sidewall

The tyre-information placard on a Oldtimer Trident sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (205/60R16 and others)

Planning cold pressures for sizes often seen on a passenger car. This Trident sample opens with 205/60R16, then 225/40R18 and 195/65R15.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/60R16342.34234Taller 16-inch
225/40R18362.48248Low-profile 18-inch
195/65R15342.34234Very common compact
205/55R16342.34234Typical mid-compact OEM
225/50R17352.41241Touring 17-inch
185/65R15332.28228Small / older car
215/55R16342.34234Slightly wider 16-inch
215/50R17352.41241Plus-size 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

Steering feel on the Trident lives on this axle. Do not drop front pressure to “soften” a plus-size 195/65R15; you will roll the sidewall in a roundabout.

How to set the Trident

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Trident numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Oldtimer Trident band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Trident.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Oldtimer notes

No special Oldtimer exception: the Trident uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Oldtimer Trident usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Oldtimer sticker and this page disagree, the sticker wins.

Other Oldtimer models

Questions about this Trident

What is that in bar and kPa for the Trident?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 195/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/60R16, 225/40R18 and 195/65R15 as a planning band.

How often should I check a Trident?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Oldtimer Trident use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a Oldtimer Trident?

No. Sidewall PSI is a maximum. The Trident placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation