UK · EU reference Tyre Pressure

Oldtimer · Opel · kPa

Oldtimer Opel kPa inflation table

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

kPa

231 / 231

2.31 / 2.31 bar · 32-35 / 32-35 psi

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Kilopascals show up on some Asian stickers and ISO sheets. 231 kPa front and 231 kPa rear is the Oldtimer Opel midpoint (100 kPa = 1 bar). Size estimates on this page include 245/40R18, 215/50R17 and 225/40R18 — interpolated from the catalogue midpoint, not a second factory sticker.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this Opel sticker uses SI units.

kPaBarPSI
2072.0730
2212.2132
2282.2833
2312.3133.5
2412.4135
2482.4836
2622.6238
2762.7640
3033.0344
3453.4550
4144.1460

Estimated pressure by tyre size (245/40R18 and others)

245/40R18 is the first planning size here. 225/40R18 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
245/40R1836362.482.48248248Wide touring 18-inch
215/50R1735352.412.41241241Plus-size 17-inch
225/40R1836362.482.48248248Low-profile 18-inch
215/55R1634352.342.41234241Slightly wider 16-inch
205/55R1634342.342.34234234Typical mid-compact OEM
195/65R1534342.342.34234234Very common compact
185/65R1533332.282.28228228Small / older car
225/45R1735352.412.41241241Sport 17-inch

Oldtimer Opel placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Opel is the pillar sticker, near 34/34 psi.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Opel.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Opel

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Opel numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Oldtimer notes

No special Oldtimer exception: the Opel uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Oldtimer Opel usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Oldtimer sticker and this page disagree, the sticker wins.

Other Oldtimer models

Questions about this Opel

Front versus rear on the Oldtimer Opel?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Oldtimer Opel?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Oldtimer Opel?

No. Sidewall PSI is a maximum. The Opel placard is the operating target, near 32-35/32-35 psi.

What is that in bar and kPa for the Opel?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation