UK · EU reference Tyre Pressure

Oldtimer · Chevrolet · Overview

Tyre pressure chart for the Oldtimer Chevrolet

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The Oldtimer Chevrolet catalogue band is 32-35 psi front and 32-35 psi rear — 2.2-2.4 / 2.2-2.4 bar, or about 231 / 231 kPa — measured cold. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Oldtimer tyre.

Spare and inflator kit

A matching full-size spare on the Oldtimer Chevrolet usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

How to set the Chevrolet

  1. Park the Oldtimer Chevrolet for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Chevrolet is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Oldtimer notes

No special Oldtimer exception: the Chevrolet uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Chevrolet: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

Estimated pressure by tyre size (225/45R17 and others)

Planning cold pressures for sizes often seen on a passenger car. This Chevrolet sample opens with 225/45R17, then 195/65R15 and 215/50R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/45R1735352.412.41241241Sport 17-inch
195/65R1534342.342.34234234Very common compact
215/50R1735352.412.41241241Plus-size 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
225/50R1735352.412.41241241Touring 17-inch
185/65R1533332.282.28228228Small / older car
205/60R1634342.342.34234234Taller 16-inch
215/55R1634352.342.41234241Slightly wider 16-inch

Oldtimer Chevrolet placard versus sidewall

If the Oldtimer sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Chevrolet.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

If the Oldtimer sticker and this page disagree, the sticker wins.

Other Oldtimer models

Questions about this Chevrolet

Front versus rear on the Oldtimer Chevrolet?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Oldtimer Chevrolet use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 215/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/45R17, 195/65R15 and 215/50R17 as a planning band.

Is the sidewall number correct on a Oldtimer Chevrolet?

No. Sidewall PSI is a maximum. The Chevrolet placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation