UK · EU reference Tyre Pressure

Oldtimer · Charron · Bar

Oldtimer Charron tyre pressure in bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A front-wheel drive Oldtimer Charron still wants even corners. 2.2-2.4 vs 2.2-2.4 is an axle split, not a left-right split. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Bar, PSI and kPa

Bar-led conversions around the Oldtimer Charron. 2.2-2.4 bar is not “32-35 divided by ten”.

BarPSIkPa
2.0730207
2.2132221
2.2833228
2.3133.5231
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.4550345
4.1460414

Oldtimer Charron placard versus sidewall

If the Oldtimer sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (205/55R16 and others)

If your Oldtimer Charron no longer wears the OEM diameter, start at the row nearest 205/55R16 or 225/40R18 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R1634342.342.34234234Typical mid-compact OEM
225/40R1836362.482.48248248Low-profile 18-inch
225/45R1735352.412.41241241Sport 17-inch
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact
245/40R1836362.482.48248248Wide touring 18-inch
215/55R1634352.342.41234241Slightly wider 16-inch
205/60R1634342.342.34234234Taller 16-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

How to set the Charron

  1. Park the Oldtimer Charron for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Charron is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Charron.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Oldtimer notes

No special Oldtimer exception: the Charron uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Oldtimer Charron usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Charron than nitrogen upsells.

Other Oldtimer models

Questions about this Charron

How often should I check a Charron?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Oldtimer Charron use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

When does TPMS warn on a Oldtimer Charron?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/55R16, 225/40R18 and 225/45R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation