UK · EU reference Tyre Pressure

MINI · Cooper SD Coupe · kPa

MINI Cooper SD Coupe kPa inflation table

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

kPa

231 / 231

2.31 / 2.31 bar · 32-35 / 32-35 psi

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If your gauge only speaks kPa, aim near 231 / 231 for this Cooper SD Coupe, then fine-tune to the placard. Under-inflation cooks the shoulders of a Cooper SD Coupe; over-inflation wears the centre rib and bangs every cat’s eye.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this Cooper SD Coupe sticker uses SI units.

kPaBarPSI
2072.0730
2212.2132
2282.2833
2312.3133.5
2412.4135
2482.4836
2622.6238
2762.7640
3033.0344
3453.4550
4144.1460

Estimated pressure by tyre size (195/65R15 and others)

If your MINI Cooper SD Coupe no longer wears the OEM diameter, start at the row nearest 195/65R15 or 225/40R18 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
195/65R1534342.342.34234234Very common compact
225/40R1836362.482.48248248Low-profile 18-inch
205/55R1634342.342.34234234Typical mid-compact OEM
245/40R1836362.482.48248248Wide touring 18-inch
215/50R1735352.412.41241241Plus-size 17-inch
225/50R1735352.412.41241241Touring 17-inch
185/65R1533332.282.28228228Small / older car
225/45R1735352.412.41241241Sport 17-inch

MINI Cooper SD Coupe placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Cooper SD Coupe is the pillar sticker, near 34/34 psi.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Cooper SD Coupe.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Cooper SD Coupe

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Cooper SD Coupe numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

MINI notes

MINI run-flats ride harshly if you overshoot. Stay in the printed band on this Cooper SD Coupe.

Spare and inflator kit

A matching full-size spare on the MINI Cooper SD Coupe usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Cooper SD Coupe than nitrogen upsells.

Other MINI models

Questions about this Cooper SD Coupe

Front versus rear on the MINI Cooper SD Coupe?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 205/55R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 195/65R15, 225/40R18 and 205/55R16 as a planning band.

When does TPMS warn on a MINI Cooper SD Coupe?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a MINI Cooper SD Coupe?

No. Sidewall PSI is a maximum. The Cooper SD Coupe placard is the operating target, near 32-35/32-35 psi.

What is that in bar and kPa for the Cooper SD Coupe?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation