Lexus · LS 500 · Bar

Lexus LS 500 tyre pressure in bar

Drivetrain: rear-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this LS 500 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Lexus tyre.

Bar, PSI and kPa

Bar-led conversions around the Lexus LS 500. 2.2-2.4 bar is not “32-35 divided by ten”.

Bar	PSI	kPa
2.07	30	207
2.21	32	221
2.28	33	228
2.31	33.5	231
2.41	35	241
2.48	36	248
2.62	38	262
2.76	40	276
3.03	44	303
3.45	50	345
4.14	60	414

Lexus LS 500 placard versus sidewall

The tyre-information placard on a Lexus LS 500 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (225/50R17 and others)

225/50R17 is the first planning size here. 185/65R15 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
185/65R15	33	33	2.28	2.28	228	228	Small / older car
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
225/40R18	36	36	2.48	2.48	248	248	Low-profile 18-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	38 psi / 2.62 bar

How to set the LS 500

Park the Lexus LS 500 for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a rear-wheel drive LS 500 is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this LS 500.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Lexus notes

No special Lexus exception: the LS 500 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Lexus LS 500 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this LS 500 than nitrogen upsells.

Other Lexus models

GS 430 LC 500h GS 200t GS F IS F GX 470 ES 300 IS 350

Questions about this LS 500

What is that in bar and kPa for the LS 500?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 185/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/50R17, 245/40R18 and 185/65R15 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Lexus LS 500 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a Lexus LS 500?

No. Sidewall PSI is a maximum. The LS 500 placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation