UK · EU reference Tyre Pressure

Jeep · Wrangler · Cold

Jeep Wrangler cold-inflation guide

Drivetrain
four-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Cold means the Jeep Wrangler has stood at least three hours, or covered less than about a mile. Heat from a dual carriageway run is not the number you set. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Keep side-to-side spread inside about 2 psi so the four-wheel drive hardware is not working on a radius mismatch.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Wrangler.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Wrangler

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Wrangler numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Jeep Wrangler placard versus sidewall

If the Jeep sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (235/60R18 and others)

Planning cold pressures for sizes often seen on a SUV / crossover. This Wrangler sample opens with 235/60R18, then 225/60R18 and 225/65R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/60R1836362.482.48248248Plus-size 18-inch
225/60R1835352.412.41241241Highway CUV
225/65R1735352.412.41241241Very common 17-inch
245/60R1836372.482.55248255Heavier CUV
245/55R1936362.482.48248248Low-profile 19-inch
215/70R1634342.342.34234234Compact crossover
235/65R1735362.412.48241248Mid-size SUV
255/50R2037372.552.5525525520-inch plus-size

PSI, bar and kPa

PSI-led conversions for the Jeep Wrangler band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Jeep notes

No special Jeep exception: the Wrangler uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Jeep Wrangler usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Wrangler than nitrogen upsells.

Other Jeep models

Questions about this Wrangler

What PSI if I plus-size toward 225/65R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 235/60R18, 225/60R18 and 225/65R17 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

How often should I check a Wrangler?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

When does TPMS warn on a Jeep Wrangler?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Jeep Wrangler?

No. Sidewall PSI is a maximum. The Wrangler placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation