UK · EU reference Tyre Pressure

Jeep · Comanche · kPa

Jeep Comanche tyre pressure in kPa

Drivetrain
four-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

kPa

231 / 231

2.31 / 2.31 bar · 32-35 / 32-35 psi

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If your gauge only speaks kPa, aim near 231 / 231 for this Comanche, then fine-tune to the placard. Under-inflation cooks the shoulders of a Comanche; over-inflation wears the centre rib and bangs every cat’s eye. Keep side-to-side spread inside about 2 psi so the four-wheel drive hardware is not working on a radius mismatch.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this Comanche sticker uses SI units.

kPaBarPSI
2072.0730
2212.2132
2282.2833
2312.3133.5
2412.4135
2482.4836
2622.6238
2762.7640
3033.0344
3453.4550
4144.1460

Estimated pressure by tyre size (205/55R16 and others)

Planning cold pressures for sizes often seen on a passenger car. This Comanche sample opens with 205/55R16, then 225/40R18 and 185/65R15.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R1634342.342.34234234Typical mid-compact OEM
225/40R1836362.482.48248248Low-profile 18-inch
185/65R1533332.282.28228228Small / older car
245/40R1836362.482.48248248Wide touring 18-inch
225/50R1735352.412.41241241Touring 17-inch
205/60R1634342.342.34234234Taller 16-inch
215/55R1634352.342.41234241Slightly wider 16-inch
215/50R1735352.412.41241241Plus-size 17-inch

Jeep Comanche placard versus sidewall

The tyre-information placard on a Jeep Comanche sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Comanche.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Comanche

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Comanche numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Jeep notes

No special Jeep exception: the Comanche uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Jeep Comanche usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Jeep sticker and this page disagree, the sticker wins.

Other Jeep models

Questions about this Comanche

What is that in bar and kPa for the Comanche?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Is the sidewall number correct on a Jeep Comanche?

No. Sidewall PSI is a maximum. The Comanche placard is the operating target, near 32-35/32-35 psi.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Jeep Comanche use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 185/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/55R16, 225/40R18 and 185/65R15 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation