UK · EU reference Tyre Pressure

Infiniti · G35 · PSI

Infiniti G35 tyre PSI

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

PSI is the Imperial reading most UK motorists still see on garage hoses. For the Infiniti G35 the catalogue row is 32-35 psi front and 32-35 psi rear. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Infiniti G35 placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this G35 is the pillar sticker, near 34/34 psi.

PSI, bar and kPa

PSI-led conversions for the Infiniti G35 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (225/50R17 and others)

If your Infiniti G35 no longer wears the OEM diameter, start at the row nearest 225/50R17 or 205/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/50R1735352.412.41241241Touring 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
225/45R1735352.412.41241241Sport 17-inch
225/40R1836362.482.48248248Low-profile 18-inch
195/65R1534342.342.34234234Very common compact
185/65R1533332.282.28228228Small / older car
215/50R1735352.412.41241241Plus-size 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch

How to set the G35

  1. Park the Infiniti G35 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a rear-wheel drive G35 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this G35.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Infiniti notes

No special Infiniti exception: the G35 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Infiniti G35 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Infiniti sticker and this page disagree, the sticker wins.

Other Infiniti models

Questions about this G35

What is that in bar and kPa for the G35?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Infiniti G35?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Front versus rear on the Infiniti G35?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Infiniti G35 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation