Hyundai · PALISADE · Rear

Rear axle PSI and bar on the Hyundai PALISADE

Drivetrain: front-wheel drive
Body: SUV / crossover
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi rear

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Loaded PALISADE rears often need the sticker’s second column, not a copy of the front 32-35 psi figure. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Hyundai tyre.

Hyundai PALISADE placard versus sidewall

If the Hyundai sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (245/60R18 and others)

245/60R18 is the first planning size here. 245/55R19 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
245/60R18	—	37	—	2.55	—	255	Heavier CUV
225/60R18	—	35	—	2.41	—	241	Highway CUV
245/55R19	—	36	—	2.48	—	248	Low-profile 19-inch
225/65R17	—	35	—	2.41	—	241	Very common 17-inch
235/65R17	—	36	—	2.48	—	248	Mid-size SUV
235/60R18	—	36	—	2.48	—	248	Plus-size 18-inch
255/50R20	—	37	—	2.55	—	255	20-inch plus-size
215/70R16	—	34	—	2.34	—	234	Compact crossover

Pressure against load

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	36 psi / 2.48 bar

A family SUV / crossover with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this PALISADE.

How to set the PALISADE

Park the Hyundai PALISADE for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a front-wheel drive PALISADE is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Hyundai PALISADE band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this PALISADE.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Hyundai notes

Hyundai passenger cars usually share a 32–35 psi band. A Tucson is not an i30 if the sticker disagrees.

Spare and inflator kit

A matching full-size spare on the Hyundai PALISADE usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Hyundai sticker and this page disagree, the sticker wins.

Other Hyundai models

AVENTE H 200 ACCENT Grand Santa Fe H 300 Equus Galloper Coupe

Questions about this PALISADE

Front versus rear on the Hyundai PALISADE?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Hyundai PALISADE?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Hyundai PALISADE?

No. Sidewall PSI is a maximum. The PALISADE placard is the operating target, near 32-35/32-35 psi.

What is that in bar and kPa for the PALISADE?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 245/55R19?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/60R18, 225/60R18 and 245/55R19 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation