UK · EU reference Tyre Pressure

Hyundai · iX55 · Cold

Setting cold tyres on a Hyundai iX55

Drivetrain
front-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

UK winter mornings will show a lower gauge on this iX55 without a puncture. Set 34/34 psi at ~20 °C equivalent, not after a motorway blast. Under-inflation cooks the shoulders of a iX55; over-inflation wears the centre rib and bangs every cat’s eye.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this iX55.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the iX55

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep iX55 numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Hyundai iX55 placard versus sidewall

The tyre-information placard on a Hyundai iX55 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (225/65R17 and others)

225/65R17 is the first planning size here. 225/60R18 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/65R1735352.412.41241241Very common 17-inch
245/60R1836372.482.55248255Heavier CUV
225/60R1835352.412.41241241Highway CUV
235/60R1836362.482.48248248Plus-size 18-inch
215/70R1634342.342.34234234Compact crossover
235/65R1735362.412.48241248Mid-size SUV
245/55R1936362.482.48248248Low-profile 19-inch
255/50R2037372.552.5525525520-inch plus-size

PSI, bar and kPa

PSI-led conversions for the Hyundai iX55 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Hyundai notes

Hyundai passenger cars usually share a 32–35 psi band. A Tucson is not an i30 if the sticker disagrees.

Spare and inflator kit

A matching full-size spare on the Hyundai iX55 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Hyundai sticker and this page disagree, the sticker wins.

Other Hyundai models

Questions about this iX55

What is that in bar and kPa for the iX55?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What tyre pressure should a Hyundai iX55 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 225/60R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/65R17, 245/60R18 and 225/60R18 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Hyundai iX55?

No. Sidewall PSI is a maximum. The iX55 placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation