Ferrari · FF · Bar

Ferrari FF tyre pressure in bar

Drivetrain: rear-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this FF 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Bar, PSI and kPa

Bar-led conversions around the Ferrari FF. 2.2-2.4 bar is not “32-35 divided by ten”.

Bar	PSI	kPa
2.07	30	207
2.21	32	221
2.28	33	228
2.31	33.5	231
2.41	35	241
2.48	36	248
2.62	38	262
2.76	40	276
3.03	44	303
3.45	50	345
4.14	60	414

Ferrari FF placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this FF is the pillar sticker, near 34/34 psi.

Estimated pressure by tyre size (195/65R15 and others)

195/65R15 is the first planning size here. 205/55R16 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
195/65R15	34	34	2.34	2.34	234	234	Very common compact
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
185/65R15	33	33	2.28	2.28	228	228	Small / older car
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	37 psi / 2.55 bar

How to set the FF

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep FF numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this FF.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Ferrari notes

No special Ferrari exception: the FF uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Ferrari FF usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Ferrari sticker and this page disagree, the sticker wins.

Other Ferrari models

365 12 Cilindri 208 296 GTB 400 430 Scuderia 512 330

Questions about this FF

Front versus rear on the Ferrari FF?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Is the sidewall number correct on a Ferrari FF?

No. Sidewall PSI is a maximum. The FF placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Ferrari FF use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 205/55R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 195/65R15, 245/40R18 and 205/55R16 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation