Ferrari · 430 Scuderia · Cold

Setting cold tyres on a Ferrari 430 Scuderia

Drivetrain: rear-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Cold means the Ferrari 430 Scuderia has stood at least three hours, or covered less than about a mile. Heat from a dual carriageway run is not the number you set. Size estimates on this page include 205/60R16, 225/40R18 and 225/45R17 — interpolated from the catalogue midpoint, not a second factory sticker.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 430 Scuderia.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

How to set the 430 Scuderia

Park the Ferrari 430 Scuderia for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a rear-wheel drive 430 Scuderia is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

Ferrari 430 Scuderia placard versus sidewall

The tyre-information placard on a Ferrari 430 Scuderia sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (205/60R16 and others)

If your Ferrari 430 Scuderia no longer wears the OEM diameter, start at the row nearest 205/60R16 or 225/40R18 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
225/40R18	36	36	2.48	2.48	248	248	Low-profile 18-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
195/65R15	34	34	2.34	2.34	234	234	Very common compact
185/65R15	33	33	2.28	2.28	228	228	Small / older car
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch

PSI, bar and kPa

PSI-led conversions for the Ferrari 430 Scuderia band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	37 psi / 2.55 bar

Ferrari notes

No special Ferrari exception: the 430 Scuderia uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Ferrari 430 Scuderia usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this 430 Scuderia than nitrogen upsells.

Other Ferrari models

458 330 12 Cilindri 288 275 360 550 195

Questions about this 430 Scuderia

What is that in bar and kPa for the 430 Scuderia?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Front versus rear on the Ferrari 430 Scuderia?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Is the sidewall number correct on a Ferrari 430 Scuderia?

No. Sidewall PSI is a maximum. The 430 Scuderia placard is the operating target, near 32-35/32-35 psi.

How often should I check a 430 Scuderia?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Ferrari 430 Scuderia use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation